穿越未固结湖相地层的大位移井钻井对旋转导向系统(RSS)构成严重冲蚀挑战,原因是钻井液长时间循环和高磨料固相浓度。本文介绍在非洲某陆上油田开发并现场验证的一套综合冲蚀缓解策略,用于提高RSS可靠性和钻井效率。该方法将采用超音速火焰喷涂(HVOF)施加WC-10Co-4Cr涂层对易冲蚀内部流道部件进行材料强化,与钻井液优化(强化固相控制措施、振动筛网优化、离心机性能改进、加重材料粒径细化)相结合。实验室测试表明HVOF涂层硬度超过1100 HV,相对基体合金磨损体积降低约60%,耐腐蚀性提高200 mV以上。现场…
Abstract Extended-reach drilling through unconsolidated lacustrine formations presents significant erosion challenges for rotary steerable systems (RSS) because of prolonged drilling fluid circulation and elevated abrasive solids concentration. This paper presents the development and field validation of an integrated erosion-mitigation strategy applied in an African onshore oilfield to improve RSS reliability and drilling efficiency. The proposed approach combined material strengthening of erosion-prone internal flow-path components using a WC-10Co-4Cr coating applied by High Velocity Oxygen Fuel (HVOF) thermal spraying with drilling fluid optimisation through enhanced solids-control practices, shaker screen optimisation, centrifuge performance improvement, and weighting-material particle size refinement. Laboratory testing demonstrated that the HVOF-applied coating achieved hardness values exceeding 1100 HV, reduced wear volume by approximately 60% relative to the base alloy, and improved corrosion resistance by more than 200 mV. Field implementation across multiple extended-reach well sections reduced drilling fluid sand content from 0.8–1.2% to 0.3–0.5%, resulting in a substantial improvement in RSS performance. Average downhole tool service life increased from approximately 150 hr to more than 200 hr, while single-run drilling footage improved by over 30%. Post-run inspections confirmed significant reductions in localized scour, pitting, and erosion damage on critical internal flow-path components. The results demonstrate that integrating advanced surface engineering with drilling fluid solids management provides an effective and practical approach to mitigating erosion-related RSS failures and improving drilling efficiency in abrasive drilling environments. The novelty of this work lies in the field-validated integration of component-level surface strengthening with fluid-level solids management to address both material susceptibility and abrasive particle loading under extended-reach, high-solids drilling conditions. The methodology provides a practical and transferable workflow for improving RSS reliability, reducing nonproductive time (NPT), and extending tool operating life in drilling environments with similar erosion challenges.